Find all needed information about Rapidio Support. Below you can see links where you can find everything you want to know about Rapidio Support.
https://www.idt.com/us/en/products/interface-connectivity/serial-rapidio-solutions
RapidIO solutions from IDT include bridging and switching products that are ideal for building peer-to-peer multi-processor systems with 100ns latency, low power consumption, reliable packet termination — all with industry-standard based support at up to 50 Gbps per port.
https://www.idt.com/document/apn/rapidio-software-support-application-note
RapidIO Software Support Application Note Riosocket: Ethernet Frame Transport over RapidIO Riosocket uses standard mport drivers to transport Ethernet frames over a RapidIO network. Riosocket is supported by mports that can send and receive DMA, Messaging, and doorbell RapidIO transactions.
https://www.design-reuse.com/sip/rapidio-controller-with-v4-0-support-ip-29645/
The RapidIO Controller solution (GRIO) is a highly flexible and configurable IP. The The RapidIO Controller can be used as a Host or device. The RapidIO Controller when used along with the RapidIO to AXI Bridge (RAB) provides speed multi-channel DMA, Data Message and Data streaming functionality to match the bandwidth requirements of the RapidIO interface.
https://www.kernel.org/doc/html/latest/admin-guide/rapidio.html
RapidIO is a high speed switched fabric interconnect with features aimed at the embedded market. RapidIO provides support for memory-mapped I/O as well as message-based transactions over the switched fabric network. RapidIO has a standardized discovery mechanism not unlike the PCI bus standard that allows simple detection of devices in a network.
https://www.xilinx.com/support/documentation/ip_documentation/srio_gen2/v4_1/pg007_srio_gen2.pdf
Serial RapidIO Gen2 Buffer (BUF) are designed according the RapidIO Interconnect Specification rev. 2.2 (RapidIO Specification) [Ref 13]. Although working knowledge of the RapidIO Specification is not required to use th e SRIO Gen2 Endpoint, it might be necessary to reference the specifications for details outside of the scope of this guide.
http://www.rapidio.org/rapidio-specifications/
29 rows · The RapidIO 3.0 specification, know as 10xN, increases single lane speed to 10 Gbit/s and …
https://www.kernel.org/doc/ols/2005/ols2005v2-pages-43-56.pdf
RapidIO support on the chip. 2005 Linux Symposium • 37 PCI Express and RapidIO have similar data rate capabilities. PCI Express offers lane configura-tions of x1 through x32 where each lane offers 2 Gb/s full duplex data throughput. In a typical PC implementation there is a single x16 slot for
https://community.nxp.com/thread/436750
Feb 12, 2019 · The T2080RDB board and the T2080QDS board do not support RapidIO. It is the reason that these boards were not tested for RapidIO using under SDK 2.0.Reviews: 2
Need to find Rapidio Support information?
To find needed information please read the text beloow. If you need to know more you can click on the links to visit sites with more detailed data.
