Find all needed information about Show Tech Support Redirect. Below you can see links where you can find everything you want to know about Show Tech Support Redirect.
https://www.cisco.com/c/m/en_us/techdoc/dc/reference/cli/nxos/commands/fund/show-tech-support.html
The output from the show tech-support command is very long. To better manage this output, you can redirect the output to a file (for example, show tech-support > filename) in the local writable storage file system or the remote file system. You can use one of the following redirection methods: > filename —Redirects the output to a file.
https://allthingsnetworking.wordpress.com/2013/01/21/show-tech-support/
Jan 21, 2013 · “When I’m asked by Cisco TAC to send them a #show tech-support it gives me too much information to copy to a text file?” “how can I output that information to a text file without using copy and paste?” There is a few ways you can do this, but are not limited to just below. 1. Redirect the file to tftp, ftp, http, flash etc.
https://serverfault.com/questions/430702/cisco-command-output-redirect-to-a-local-file
Although not all devices support using two pipes, and/or the redirect (or tee) command. Again, it depends on your device and OS. UPDATE To have the update sent to your local computer as C:\output.txt is only possible, when using just the built in features on the switch, via URL redirection.
https://www.tek-tips.com/viewthread.cfm?qid=1178154
Jan 19, 2006 · From Unix? Presumably you'll be telnetting from the Solaris box to the device you need to 'show tech'? Could you perhaps redirect all your output to a text file?Something like: telnet a.b.c.d > showtechoutput (enter passwords) router#show tech router#exit where a.b.c.d is the IP address of the Cisco device. Would this work?
https://routerandswitch.blogspot.com/2012/07/procedure-for-capturing-show-tech.html
Jul 15, 2012 · Show tech-support This command is used to display technical support information which can be used in troubleshooting the router.The show tech-support command displays the output of a number of show commands at once. The output from this command varies depending on the platform and configuration.
https://learningnetwork.cisco.com/thread/71630
Jun 15, 2014 · The show tech-support command is a diagnostic tool that provides extensive output of the device status. The following show commands run automatically when the show tech-support command is issued: show running-config
https://www.reddit.com/r/networking/comments/2trjxc/just_did_a_show_tech_on_a_cisco_nexus_for_the/
Just did a "show tech" on a Cisco Nexus for the first time... First of all this is technically defaulting to "show tech brief" and apparently there is a "show tech all". For comparison the "show tech" on a catalyst switch always seemed enormous to me, and weighed in at around 2MB of just text.
Need to find Show Tech Support Redirect information?
To find needed information please read the text beloow. If you need to know more you can click on the links to visit sites with more detailed data.
